Tap Magician compatible spares / parts to repair the Franke Muri Mono Mixer Kitchen tap.

If your tap is dripping or leaking out of the spout then it is time to replace / change the quarter turn ceramic disc cartridges. Original spare part codes known by 3540R, 133.0358.079, 133.0358.080, 133.0251.375 133.0251.374 hot and cold valves available

Cartridge has 28 teeth on spline. You will require our Anticlockwise open cartridge for the cold side, and clockwise open for the hot side, If you require both then you can select "Pair"
When you remove your Cartridge / Insert from the tap the bush usually remains inside the tap block however sometimes it comes out together with the valve.
If the valve is stuck inside the bush you can try to separate them.
If you are unable to separate the valve from the bush then you will need to purchase a new bush (our SB27). knpwn by SP3868 / 3868R /133.0312.538

If your tap is leaking from the neck (where the spout meets and joins the tap body) then the seals inside the spout need replacing. When you replace the new rubber seals they need greasing with a suitable silicone grease. The original O'ring kit is known by 3668R, 1260R, 133.0277.067.

If you require a new antisplasher /aerator this is our part SR63C/CB (available in Chrome or brushed) Original codes known by 133.0068.762 SP1263 /1263R your original part may have Neoperl stamped around the edge.

We now offer compatible lever handles in chrome or silksteel. Our handle is compatible with with 3735R / SP3735 / CH 133.0251.339/ 133.0251.353. *Please note our handle is plain (not stamped H or C) and is suitable for both hot and cold sides. Handle comes complete with new grub screw. If you need a new handle screw only this is our SS81-S

FAQ
How do I remove the handle on the Muri kitchen tap?
Use 2mm allen key to undo screw on the underside of the handle. Pull handle off. Unscrew shroud by unscrewing anticlockwise.

How do I know if need the adaptor bush?
Until you remove the cartridge from the tap you will not know if you need this part.
This is because sometimes the bush gets corroded to the tap and remains in the tap body, and other times it comes out corroded to the tap cartridge.

Can I remove the adaptor bush from the old cartridge?
Yes you can but it can be very hard to remove due to corrosion. You can try using very hot water, followed by cold water over it, to help break the corrosion seal. The bush unscrews from the cartridge anticlockwise. You will likely ed to use some grips or put it in a vice to remove it. If you cannot separate it you will need to replace the bush.

You can find the Muri tap / instruction diagram below.