FRANKE MARIS PULL OUT SPRAY TAP SPARES

Watch our video below for guidance / how to remove your handles and change your Quarter turn ceramic cartridge

Tap Magician compatible spares / parts to repair the Franke Maris Pull Out Nozzle / Spray Mono Mixer Silk Steel and Chrome Kitchen tap 115.0363.793.

If your tap is dripping or leaking out of the spout then it is time to replace / change the quarter turn ceramic disc cartridges. Original spare part codes known by SP3308, 3308R, SP3794 3794R, 133.0358.055, 133.0358.053 133.0150.220, 133.0150.219, Hot and cold valves available.

Cartridge has 28 teeth on spline. You will require our Anticlockwise open cartridge for the cold side, and clockwise open for the hot side, If you require both then you can select "Pair"
Your tap handle may utilise a plastic handle adaptor / tap head carrier. Sometimes this can wear or break and we can supply this part if you require a new one (Our part SA03-S).

We now offer compatible lever handles. These do not match the originals so must be replaced together as a set (pair) so that they match. Our handles are plain and do not have H or C stamped on them. They come supplied with a new grub screw. Our handles do not use the plastic handle adaptor.

Franke Maris Pull Out Spray FAQs

How to remove the Franke Maris Pull Out Spray Tap handle and replace the cartridge?
Before replacing the cartridge you will need to turn the water off.
Step 1. Remove the handle retaining screw, by using a 2.5mm allen key.
Step 2. Pull the handle away from the tap body.
Step 3. You’ll then need a crosshead screwdriver to remove the screw holding the white plastic sleeve in place.
Step 4. With the handle adaptor sleeve removed use our ST03-S cartridge removal tool to unscrew the cartridge.
Step 5. Replace the cartridge and reverse the steps to refit the handle.

How to remove your cartridge.
Our Cartridge Valve removal tool (ST03) is available to enable easy removal and fitting of the cartridges which are recessed into the tap body. The old valve may have two flats instead of a hex nut. Our tool has two ends. One end to remove the cartridge with two flats and one end to remove/fit new cartridge with hex nut.

How to remove the Franke Maris Pull Out Spray Tap Spout and replace the O Rings?
To replace the o rings you will first need to remove the hose. To do this, unscrew the hose from underneath the tap and pull through from the end of the spout.
To replace the o rings, you will need to remove the spout retaining screw by using a 2.5mm allen key. Once you’ve removed the spout, you can replace the existing o rings with the new parts.

You can find the Maris Pull Out Spray Tap instruction diagram below.