RANGEMASTER AQUADISC 4 TAD4CM KITCHEN TAP SPARES
Watch our video below for guidance / how to change your Quarter turn ceramic valves and Spout O Rings.
Replacement spare parts to fit the Rangemaster Leisure Aquanomic Aquadisc 4 TAD 4 CM (4 TAD4CM /-AN) kitchen mixer tap.
If your Aquadisc 4 TAD 4 CM tap is dripping or leaking out of the spout then it is time to replace / change the quarter turn ceramic disc cartridges.
Cartridge has 28 teeth on spline. Original part code SP3308 3308R and spline adaptor 3530R.
You will require our Anticlockwise open cartridge for the cold side, and clockwise open for the hot side, If you require both then you can select "Pair".
If your tap is leaking from the neck (where the spout joins the tap body) then the seals inside the spout need replacing. When you replace the new rubber seals they need greasing with a silicone grease. The original O'ring kit is known by 1239R, SP1239.
If you need a new complete spout this is our code SPOUT01C and comes complete with aerator and o rings.
Please note our spout is a tall swan neck style spout.
Replacement aerator available as SR24C-S. Known by original spare part codes 3587R SP3587.
How to remove the Rangemaster 4 TAD 4 tap handle and replace the cartridge?
Before replacing the cartridge you will need to turn the water off.
Step 1. Remove the handle retaining screw, by using a 2.5mm allen key.
Step 2. Pull the handle away from the tap body.
Step 3. You’ll then need a crosshead screwdriver to remove the screw holding the white plastic sleeve in place.
Step 4. With the handle adaptor sleeve removed use our ST03-S cartridge removal tool to unscrew the cartridge.
Step 5. Replace the cartridge and reverse the steps to refit the handle.
How to remove the Aquadisc 4 TAD4CM cartridge.
Our Cartridge Valve removal tool (ST03) is available to enable easy removal and fitting of the cartridges which are recessed into the tap body. The old valve may have two flats instead of a hex nut. Our tool has two ends. One end to remove the cartridge with two flats and one end to remove/fit new cartridge with hex nut.
How to replace the spout O'rings on the Aquadisc 4 TAD4CM kitchen tap?
Step 1. Whilst holding body unscrew the spout locking collar anticlockwise.
Step 2. Once removed pull the spout vertically away from the body.