Replacement Cartridges and spares to fit the Rangemaster Monorise TMR1CM kitchen mixer monobloc tap.

Watch our tutorial how to guide to take you through step by step. Purchase as a single (left or right hand side) or a pair. If you do not know which side is leaking we recommend replacing both

Original part code SP3308 3308R

If your tap is dripping or leaking out of the spout then it is time to replace / change the quarter turn ceramic disc cartridges. Original spare part codes known by ASCDV0009 / 3794R / SP3794/ 3794R / SP3308 / 3308R.

Cartridge has 28 teeth on spline. You will require our Anticlockwise open cartridge for the cold side, and clockwise open for the hot side, If you require both then you can select "Pair".

If your Rangemaster Monorise tap is leaking from round the neck (where the spout joins the tap body) then the seals inside the spout need replacing. You need to replace all parts from the O'Ring seal kit.
The original O'ring kit is known by 1239R. You should apply silicone grease to the o rings before replacing the spout.

Complete compatible spout available (compatible with 3756R) however locking collar at base of spout is tapered rather than straight.

If you require a new antisplasher /aerator this is our part SR63C/CB (available in Chrome and Brushed Chrome only).
Original codes known by 133.0068.762 SP1263 /1263R CH. Your original part may have Neoperl stamped around the edge.

Your monorise tap handle may utilise a plastic handle adaptor / tap head carrier. Sometimes this can wear or break and we can supply this part if you require a new one (Our part SA03-S). Original tap handle adaptor code SP3530.

We now offer a compatible lever handle set, please note our design is different to the original so the handles must be replaced as a set. Our handles do not utilise the plastic handle adaptor. Available in chrome or brushed.

FAQ
How to remove your monorise tap cartridge?
Our Cartridge Valve removal tool (ST03) is available to enable easy removal and fitting of the cartridges which are recessed into the tap body. The old valve may have two flats instead of a hex nut. Our tool has two ends. One end to remove the cartridge with two flats and one end to remove/fit new cartridge with hex nut.

How to remove my Rangemaster monorise tap handle?
Use a Allen key to remove grub screw on the underside of the handle. The handle will then pull off.