LAMONA RHONE KITCHEN TAP SPARES
Watch our video below for guidance / how to change your Quarter turn ceramic valves and Spout O Rings.
The video was taken on the Lamona Hi Tech but the handles and spout kit are the same.
Tap Magician compatible spares / parts to repair the Lamona Rhone Kitchen Mixer Monobloc Tap
Chrome TAP3456, Matt Black TAP3457, Gloss White TAP3458, Grey TAP3460.
If your Rhone tap is dripping or leaking out of the spout then it is time to replace / change the quarter turn ceramic disc cartridges.
Original spare part codes known by 3984R / SP3984 / ASSCDV0001. Cartridge has 28 teeth on spline.
Hot and cold valve replacements available.
You will require our Anticlockwise open cartridge for the cold side, and clockwise open for the hot side,
If you require both then you can select "Pair".
If your cartridge comes out stuck inside the brass bush/ring and you cannot separate then you will need to purchase a new one which is our code SB34-S, known by part code 3408R.
If your tap is leaking from the neck (where the spout joins the tap body) then the seals Inside the spout need replacing.
When you replace the new rubber seals they need greasing with a silicone grease. The original O'ring kit is known by 1239R.
If you require a new complete spout we have a swan neck spout in chrome compatible with 1306R. Our spout comes complete with locking nut, o rings and aerator.
If you require a new antisplasher / aerator this is our part SR63C/CB (available in Chrome or brushed).
Original codes known by 133.0068.762 SP1263 /1263R your original part may have Neoperl stamped around the edge.
If you need new handles for your Rhone tap we can offer a tap reviver kit (cartridges and handle) the cartridges are different to the original cartridges so much be purchased as a complete set to replace all together.
You can find the Rhone tap instructions diagram below.
How to remove the Lamona Rhone tap handle/head?
Before replacing the cartridge you will need to turn the water off.
Step 1. Lever out the screw cover cap (tap indice). You can use a small precision screwdriver or fingernail
Step 2. Use a crosshead screwdriver to undo the screw
Step 3. Pull off the handle
Step 4. Use an adjustable spanner to undo the cartridge counterclockwise
Step 5.Screw in the new cartridge clockwise
Step 6. Tighten the cartridge enough to seal, but avoid over-tightening
How to remove the Lamona Rhone spout and replace the O rings
Step 1. Whilst holding the tap body unscrew the spout locking collar
Step 2. Pull the spout vertically away from the body
Step 3. Remove the old O rings using a small screwdriver or similar.
How can I stop my tap dripping? can I repair my tap?