Tap Magician replacement spare parts for the Lamona Garda Filter TAP1130.
Quarter turn ceramic valves and Spout O Rings


We can only supply the hot cartridge, we cannot supply the cold tap cartridge which does both the mains cold and filtered cold.

Cartridge has 28 teeth on spline. Original cartridge code 4276R.

If your tap is leaking from the neck (where the spout joins the tap body) then the seals inside the spout need replacing.
When you replace the new rubber seals they need greasing with a silicone grease.
O Ring Kit is known by spare part code 1425R, The ceramic cartridge is known by spare part code 3984R.

You can find the Lamona Garda Filter TAP 1130 tap diagram/instructions below.

How to replace the hot valve:
Loosen grub screw on the underside of handle using a 2mm allen key (SK01-S). Pull the handle horizontally away from the tap.

How to replace the spout o-rings:
Loosen grub screw on the rear of body using a 2.5mm allen key (SK01-S). Pull the spout vertically away from the body.



Lamona Garda Filter tap Frequently asked questions

How to I remove the Lamona Garda tap handle?
Use 2mm allen key to undo handle. The grub screw is located on the underside of the handle. You can pull the lever forwards to access the screw at the back if you need more space.

How do I know if need the adaptor bush?
Until you remove the Hot cartridge from the tap you will not know if you need this part. This is because sometimes the bush gets corroded to the tap and remains in the tap body, and other times it comes out corroded to the tap cartridge.
Can I remove the adaptor bush from the old cartridge?
Yes you can but it can be very hard to remove due to corrosion. You can try using very hot water, followed by cold water over it, to help break the corrosion seal. The bush unscrews from the cartridge anticlockwise. You will likely ed to use some grips or put it in a vice to remove it. If you cannot separate it you will need to replace the bush.
How do I remove the spout and replace the o'rings inside the spout?
Use 2.5mm allen key to undo grub screw at the back holding the spout in place. pull spout up and out of the tap body. You can watch our How to video above.
What size spanner do I need to remove the Garda tap handle?
You will need a 17mm or an adjustable spanner