RANGEMASTER AQUATREND PULLOUT TAP SPARES

Tap Magician compatible spares for the Aquatrend Spring & Pull out dual lever kitchen lever tap.
Replacement tap spares compatible with tap models TRE1P0BF TRE1POCM TRE1SPRCM.

Watch our video below for a tutorial guidance on how to change your quarter turn ceramic valves and spout O'Rings.

If your tap is leaking/dripping out of the spout then it is time to replace the cartridges.
Our cartridge is compatible replacements for the original 4276R / 3561R coded cartridges.

When you remove your old valve from the tap the bush usually remains inside the tap block however sometimes it comes out together with the valve.
If the valve is stuck inside the bush you can try to separate them.
If you are unable to separate the valve from the bush then you will need to purchase the valve together with the bush.
Tap Magician replacement bush product code SB27-S is compatible with original bush code 3868R.

The Rangemaster Aquatrend pull out tap cartridge has 28 splines.
You will require our Anticlockwise open cartridge for the cold side, and clockwise open for the hot side.
If you require both then you can select "Pair".

If your tap is leaking from the swivel spout neck where it joins the tap body the seals inside the spout need replacing.
When you replacing the rubber seals you will need to apply silicone grease to these.
You will need our SK19-S O'ring kit compatible with original product codes 1425R SP1425.

Replacement spray head available in chrome SRSPRAYC-S.

Rangemaster Aquatrend Frequently asked questions

How to I remove the Rangemaster Aquatrend tap handle / levers?
Use 2mm allen key to undo handle. The grub screw is located on the underside of the handle.
You can pull the lever forwards to access the screw at the back if you need more space.

How do I know if need the adaptor bush?
Until you remove the cartridge from the tap you will not know if you need this part.
This is because sometimes the bush gets corroded to the tap and remains in the tap body, and other times it comes out corroded to the tap cartridge.

Can I remove the adaptor bush from the old cartridge?
Yes you can but it can be very hard to remove due to corrosion.
You can try using very hot water, followed by cold water over it, to help break the corrosion seal.
The bush unscrews from the cartridge anticlockwise. You will likely need to use some grips or a vice to separate it.
If you cannot separate it you will need to replace the bush.

How do I remove the spout and replace the o'rings inside the spout?
Use 2.5mm allen key to undo grub screw at the back holding the spout in place.
Pull spout up and out of the tap body. You can watch our How to video above.

What size spanner do I need to remove the Garda tap handle?
You will need a 17mm or an adjustable spanner.

You can find the aqua trend tap instruction diagram below.