Watch our video below for a tutorial guidance / how to change your Quarter turn ceramic valves and Spout O Rings.
RANGEMASTER AQUATREND SPRING TAP SPARES
Tap Magician fully compatible spares for the Aquatrend Spring / Pull out dual lever TRE1SPRCM kitchen Mixer Lever tap.
If your tap is leaking/dripping out of the spout then it is time to replace the cartridges.
Our cartridge is compatible with 4276R /3561R.
When you remove your old valve from the tap the bush usually remains inside the tap block however sometimes it comes out together with the valve.
If the valve is stuck inside the bush you can try to separate them.
If you are unable to separate the valve from the bush then you will need to purchase the valve together with the bush.
You will need our conversion bush is our code SB27, original code 3868R.
The Rangemaster Aquatrend Pullout Spring tap cartridge has 28 splines.
You will require our Anticlockwise open cartridge for the cold side, and clockwise open for the hot side.
If you require both then you can select "Pair".
If your tap is leaking from the neck (where the spout joins the tap body) then the seals inside the spout need replacing.
When you replace the new rubber seals they need greasing with a silicone grease.
The original O'ring kit is known by 1425R SP1425.
Rangemaster Aquatrend Frequently asked questions
How to I remove the Rangemaster Aquatrend tap handle / levers?
Use 2mm allen key to undo handle. The grub screw is located on the underside of the handle.
You can pull the lever forwards to access the screw at the back if you need more space.
How do I know if need the adaptor bush?
Until you remove the cartridge from the tap you will not know if you need this part.
This is because sometimes the bush gets corroded to the tap and remains in the tap body,
and other times it comes out corroded to the tap cartridge.
Can I remove the adaptor bush from the old cartridge?
Yes you can but it can be very hard to remove due to corrosion.
You can try using very hot water, followed by cold water over it, to help break the corrosion seal.
The bush unscrews from the cartridge anticlockwise. You will likely need to use some grips or put it in a vice to remove it.
If you cannot separate it you will need to replace the bush.
How do I remove the spout and replace the o'rings inside the spout?
Use 2.5mm allen key to undo grub screw at the back holding the spout in place.
Pull spout up and out of the tap body. You can watch our How to video above.
What size spanner do I need to remove the Aquatreand tap handle?
You will need a 17mm or an adjustable spanner.
You can find the aqua trend tap / instruction diagram below.