LAMONA RIENZA TAP SPARES
Watch Rienza our video below for guidance / how to change your Quarter turn ceramic valves.

Replacement spare parts for the Howdens Lamona Rienza kitchen mixer tap MODELS TAP1140,TAP8308,TAP3547,TAP3557, TAP3545.

*****Please note for the Rienza filter tap TAP1140 we can only supply the HOT cartridge.

If your tap is dripping or leaking out of the spout then it is time to replace / change the quarter turn ceramic disc cartridges.
Original spare part codes known by 3984R / SP3984 / ASSCDV0001, hot and cold valve replacements available.

Cartridge has 20 teeth on spline.
You will require our Anticlockwise open cartridge for the cold side, and clockwise open for the hot side,
If you require both then you can select "Pair".

If your cartridge comes out stuck inside the brass bush / ring and you cannot separate then you will need to purchase a replacement.
This is our part code SB34-S. Original part code known by 3408R.

If your tap is leaking from the neck (where the spout joins the tap body) then the seals Inside the spout need replacing.
When you replace the new rubber seals they need greasing with a silicone grease.
The original O'ring kit is known by 1239R.

If you require a new complete spout we have a swan neck spout in chrome compatible with 1306R. Our spout comes complete with locking nut, o rings and aerator.

If you require a new antisplasher / aerator this is our part SR63C/CB (available in Chrome or brushed).
Original codes known by 133.0068.762 SP1263 /1263R your original part may have Neoperl stamped around the edge.

If you need a new handle/ lever for the Rienza this is our SH0ATH-S in chrome please note our handle is plain and not stamped H or C

How to remove the tap handle / head and replace the carridge:
Turn water off before starting these steps
1. Remove the end screw cover cap (tap indice).
2. Use crosshead screwdriver to undo screw.
3. Pull handle / head off.

4. Use 17mm or adjustable spanner to undo cartridge anticlockwise
5. Repeat steps in reverse to fit new cartridge and refit handles

How to remove and replace the spout o-rings:
Unscrew locking collar at base of spout. Pull tap up and away from tap body

You can find the Rienza tap diagram/instructions below.