Tap Magician replacement ceramic tap cartridges to fit the Franke FILTERFLOW Doric kitchen tap 120.0615.357.

This cartridge is NOT compatible with the TRIFLOW Doric - You can find the correct cartridge for the Triflow version by clicking here to view


Watch our video below for guidance / how to remove your handles and change your Quarter turn ceramic valves and Spout O Rings.

When you remove your old valve from the tap the bush usually remains inside the tap block however sometimes it comes out together with the valve. If the valve is stuck inside the bush you can try to separate them. If you are unable to separate the valve from the bush then you will need to purchase the valve together with the bush.

The Franke cartridge may be known by the following spare part references; s1022 , SP3561, 3561R, 1427R, 133.0438.152, 133.0438.154, 133.0069.364, 133.0069.365 , 133.0194.088, 133.0194.089
The Brass bush is known by code 3868R

If your Doric tap is leaking from the base of the spout where the spout meets the tap body (the neck) then you will need to replace the O Rings / washers inside the spout. The O'ring kit is known by original part number SP2300, 2300R.

If you need a new aerator(end nozzle/anti-splasher) this is part SR02OL and is compatible with 3620R only currently available in chrome

Franke Filterflow Doric Frequently asked questions

How to I remove the Franke Doric tap handle?
Use 2mm allen key to undo handle. The grub screw is located on the underside of the handle.
You can pull the lever forwards to access the screw at the back if you need more space.
To remove the Franke Olympus G model you will need to unscrew the upright lever by unscrewing it anticlockwise.
You can then remove the valve cover which then releases the rest of the handle.

How do I know if need the adaptor bush?
Until you remove the cartridge from the tap you will not know if you need this part.
This is because sometimes the bush gets corroded to the tap and remains in the tap body, and other times it comes out corroded to the tap cartridge.

Can I remove the adaptor bush from the old cartridge?
Yes you can but it can be very hard to remove due to corrosion. You can try using very hot water, followed by cold water over it, to help break the corrosion seal. The bush unscrews from the cartridge anticlockwise. You will likely ed to use some grips or put it in a vice to remove it. If you cannot separate it you will need to replace the bush.

How do I remove the spout and replace the o'rings inside the spout?
Use 2.5mm allen key to undo grub screw at the back holding the spout in place. pull spout up and out of the tap body. You can watch our How to video above.

What size spanner do I need to remove the Franke filterflow doric tap handle?
You will need a 17mm or an adjustable spanner



You can find the Filterflow Doric tap diagram/instructions below.